Seismic Lokton 60-grit Griptape sheet 11x40"

These Lokton sheets are available in Honeycomb, Metal-Plate, Ninja and Fishnet pattern. The hole patterns decrease weight by up to 40%, while hole edges increase grip on your longboard deck.
Although this 60 grit version classifies as standard griptape, it is quite grippier than most griptapes out there. We recommend this grip for freeride boards, for long-distance or those who like a lot of grip on their board. Make sure you apply this griptape on clean, dry deck surfaces at room temperature.

For best results, follow these directions:

1) If deck is coated with excess lacquer, buff with fine sandpaper and clean off residue with Naptha.
2) Use a blow dryer or heat gun to warm up Lokton after removing release paper but before placing on deck.
3) Place on deck, then immediately apply pressure by standing on all areas of the Lokton.
4) Trim edges by cutting from the top. Do not bend or file edges, as this can cause excessive grain shedding.

Lokton does not always adhere well to the top of other grip tape, but it will conform to the contours of most concaves and implants. The Ninja lasercut conforms more easily to deeper concaves.

The PSA (pressure-sensitive adhesive) on the back of Lokton is some of the best, most heat-resistant on the market. However, it does not always bond well to unusual combinations of deck-top materials and finishes, especially certain types of Formica and heavy lacquer. The results may vary.

Color: Midnight Blue
Size: 101.6 cm x 27.9 cm / 40" x 11"
Type: Standard
Grit: 60